ZECKOROLL REV ‘A’ OCT 2018
14
2
IMPORTANT SAFETY INSTRUCTIONS
This document contains important safety and operation instructions for tool storage units. Refer to this information often for safe usage
and operation.
SAVE THESE INSTRUCTIONS
When using electric products, basic precautions should
always be followed, including the following:
Improper assembly can cause unsafe conditions.
Read instructions before using or assembling.
Maintain safety labels. If label is worn or damaged,
replace label.
Unsafe conditions can cause injury.
Particles may y during assembly.
Wear safety goggles. (User and bystanders)
Flying particles can cause eye injury.
To reduce the risk of injury, close supervision is
necessary when this product will be used around
children.
Keep children away.
Unsupervised children can be injured.
To reduce the risk of injury, never overload drawers or
shelves.
Refer to installation and loading instructions.
Overloaded drawers or shelves can cause injury or
damage.
Units can tip or strike you.
• Do not open more than one loaded drawer at a
time
• Do not force open a drawer kept closed by
drawer control slide
• Close lid and lock drawers before moving
• Apply brakes on locking casters when not
moving unit
• If unit begins to tip, stand clear
• Do not open any drawer with swivel caster
positioned inward
• Do not step in or on drawers
• Do not use any open drawer as support or
leverage
• Do not use add-ons as stanalone units
• Units to be used on level ground only
• Secure units together with fasteners
• Disconnect or unplug all power cord and cable
assemblies before moving unit
Tipping of storage unit or unit striking you can cause
injury.
Component edges can cut or pinch.
• Wear gloves when removing and installing
components into power drawer
• Keep ngers clear of edges when working near
or with sheet metal components
• Keep hands and ngers clear of prybar or sharp
objects
Units’ edges or components can cause injury.
Risk of electric shock and re.
• Refer to loading instructions or markings for
the proper load on receptacles
• Do not remove the ground connection
• Do not expose to rain, snow, or wet conditions
• Do not operate with damaged cord or plug
• Replace damaged cord or plug immediately
Electric shock or re can cause injury.
Risk of explosion.
• Flammable fuel or vapors can ignite
• This equipment should not be located in a re-
cessed area or below oor level
• Powered worksurface and power drawer have
internal arcing or sparking parts
• Do not expose to ammable vapors. Powered
worksurface and power drawer components to
be mounted at least 460 mm (18 inches) or more
above the oor.
Explosion or ame can cause injury.
Risk of electrical shock and re.
• 12A maximum cumulative load for all recepticles
Electrical shock or re can cause injury.
Risk of tripping.
• Do not use extension cords with power drawer
or powered worksurface outlets
• Do not place any power cord or cable assembly
in walkway
• Disconnect or unplug all power cords and cable
assemblies before moving unit
Tripping can cause injury.
NOTE: This caution applies to tool storage units that use 120VAC, 60Hz.
For tool storage units that use power other than 120VAC, 60Hz, refer to
owner’s manual supplement for max cumulative load.
To Next Page
Loading...
Need help?
General
