Snap-On ECKO User Manual (English)

Questions and Answers:

J
Joseph YatesAug 2, 2025
Why Snap-On ECKO remote lock is not responding but the remote lights up?
- J
  Jessica WatsonAug 2, 2025
  If your Snap-On Security System remote lights up but doesn't respond, several factors could be the cause. The remote battery might be low, so try removing and reinstalling or replacing it. Ensure the receiver module is receiving power by checking the AC/DC adapter and connections. The remote may be out of range, so move closer to the TSU. You can also try resetting it by unplugging and re-plugging the remote lock cord on the back of the ECKO receiver and TSU. It's also possible that the remote is not paired with the receiver module; in that case, consult the Remote pairing section of the manual.
M
Marvin KlineAug 7, 2025
What to do if Snap-On Security System remote response is poor?
- C
  Carol SimonAug 7, 2025
  If you are experiencing poor or intermittent response from your Snap-On Security System remote, it could be due to a low remote battery. Try removing and reinstalling or replacing the remote battery. Alternatively, the remote may be out of range. Try moving closer to the TSU.
R
Ricky Cortez MDAug 12, 2025
How to fix Snap-On ECKO remote that does not light up?
- J
  Joseph PowersAug 12, 2025
  If your Snap-On Security System remote does not light up, the remote battery might be low. You should try removing and reinstalling the remote battery, or replace it with a new one.
P
Penny StewartAug 17, 2025
What to do if Snap-On ECKO receiver module speaker sounds but the unit doesn't lock or unlock?
- D
  David BoltonAug 17, 2025
  If the receiver module speaker sounds but the Snap-On Security System unit does not lock or unlock, the actuator might be jammed or not moving freely. Try pushing in the drawers, manually unlocking and locking the TSU to free the lock rod and actuator. You can also try unplugging and re-plugging the remote lock cord on the back of the ECKO receiver and TSU.
M
Melissa WellsAug 22, 2025
Why Snap-On ECKO self-test start up provides tone other than 3 rising beeps?
- W
  Wendy AndersonAug 23, 2025
  If the Snap-On Security System self-test startup provides a tone other than 3 rising beeps, it indicates that the receiver failed the self-test. Check the sensor board and sensor board cable to ensure correct assembly. The sensor board should be connected to the main board. If damaged, replace the module.
R
Robert ContrerasAug 27, 2025
Why are the drawers still unlocked after locking Snap-On ECKO unit?
- T
  Troy KingAug 27, 2025
  If the drawers are still unlocked after locking the Snap-On Security System unit, it is likely that the drawers were not fully closed before locking.