ZECKOROLL REV ‘A’ OCT 2018
14
7
Setting Up ECKO Remote Lock
Each remote lock equipped TSU comes pre-pro-
grammed from the factory with the drawers
locked. Follow these steps to setup your ECKO
remote lock for the rst time:
1. Unlock the TSU using the procedure outlined
in the manual unlocking/locking section of this
manual.
2. Locate your AC/DC adapter and plug into
an electrical outlet that is properly installed and
grounded.
3. Plug the round DC end of the adapter into
the jack on the back of the TSU.
4. Use remote to lock or unlock the TSU as
explained in the remote section of the manual.
Remote Use
The remote is a three button design similar to an
automotive remote.
- Press lock key (1) 1-3 seconds to lock - 1 beep
will sound
- Press unlock key (2) 1-3 seconds to unlock - 2
beeps will sound
- Auxiliary (ACC) key is for future use
- If red LED does not turn on when pressing lock
or unlock, battery may be low
Maintenance
Remote Battery Replacement
1. Locate keyway location on remote case.
2. Using small at head screwdriver (or equiva-
lent), separate two halves of remote case.
3. Remove battery (CR2032) out of its holding
bracket.
4. Slide new battery into holding bracket with posi-
tive (+) side up.
5. Reassemble remote case by pressing two
halves rmly together.
To Next Page
Loading...
Need help?
General
