Page 17 Operation Manual
DANGER!!
Keep hands and fi ngers
clear of mount/demount
head during operation.
D. Liberally lubricate both beads. Place the wheel WITH
DROP CENTER UP (Fig. 4.1-3a) on the turntable, and
clamp in position. It may be necessary to hold the tire and
wheel down while clamping to insure contact between rim
and clamp as shown in 4.1-3a.
331
Fig. 4.1-3 Fig. 4.1-3a
WARNING: MOVE YOUR HANDS AWAY FROM
THE RIM BEFORE OPERATING THE TOOL DOWN-
STROKE.
E. Gently position the mount/demount head in contact with
the rim edge and lock it into place: the tool automatically
moves away from the rim edge vertically and horizontally,
approximately 1/16” (2mm): this is necessary to avoid
any rim contact during the changing process. (Fig. 4.1-4).
332a
Fig. 4.1-4
NOTE:
1/16”
EEWH311B Air-Electric Tire Changer
To Next Page
Loading...
