Snap-On MIG160i - Aluminum Torch Installation

MIG1606'
ALUMINUM'TORCH'INSTALLATION'
1.##Remove#the#steel#welding#wire#and#torch#assembly#if#installed.#
2.##Remove#the#steel#drive#roller#by#loosening#the#set#screw.###
3.##Remove#the#set#screw#and#install#into#the#aluminum#drive#roller#(part#number#
CKS3080942).##Install#with#the#.035”#U-groove#toward#the#inside#of#the#welder#and#Jghten#
the#set#screw.#
4.##Remove#the#brass#tube#in#the#torch#housing#and##
save.##The#tube#needs#to#be#installed#when#using#all#
other#welding#wire#but#aluminum.#
5.##Install#the#aluminum#torch.###
The#liner#sJck#out#should#just#stop#just#short#of#the#drive#roller.#
#
#
#
#
6.##Install#the#enclosed#aluminum#.035”#wire#and#feed#it#into#the#guide#tube#and#then#into#
the#torch#liner.#######
#
#
#
#
#
7.##Close#the#drive#arm#and#be#careful##
that#the#aluminum#wire#is#aligned#in#the#roller#grove.##
Very'Important!'Do#not#over#increase#the#wire##
roller#tension#with#the#tension#knob.##This#will##
cause#the#wire#to#“bird#nest”#between#the#roller##
and#the#liner.##The#factory#adjustment#should#be#the#correct#tension#exposing#
approximately#four#rings.#
8.##Set#the#synergic#curve#for#ALMG5#.035”#100%#Argon.#
9.##Install#the#flow#regulator#to#a#tank#of#100%#Argon#and#adjust#the#flow#to#40#CFH.#
10.##Set#the#material#thickness#and#you#are#ready#to#weld.#
#
#####
#
#
#
#
##