Snapper 11 Series - Page 8

ONCE A YEAR
STAND MOWER ON REAR BUMPER
• BLADE SPINDLE : Two shots of grease through
grease fitting (2-L) is required. The fitting is between
the deck and the blade.
FIG. 3
• DIFFERENTIAL: Remove the DIFFERENTIAL
CHECK PLUG (5-L) at A. If the level of grease is
below the bottom edge of hole, add SNAPPER 0
grease until it reaches the bottom edge, by removing
the plug at B and filling the differential through that
hole. Install new plugs after servicing.
• CHAIN CASE: Remove CHAIN CASE CHECK
PLUG (3-L) and add about 1 ounce of SNAPPER 0
grease to case if low - avoid over filling. Total capaci¬
ty must not exceed 2 ounces. Install new plug.
FIG. 4 - DIFFERENTIAL LUBE LEVEL
FUEL FILTER
The in-line filter (between fuel tank and engine) pro¬
tects the engine from damage due to gasoline im¬
purities. Also, check the hose clamps for any
leakage. Replace the filter (SNAPPER#1-4359) before
the screen becomes completely clogged with sedi¬
ment. When the filter appears dark (in the screen
area), and/or if the engine becomes "starved"for fuel
- It will not accelerate properly, misses, or stalls
under load, the filter should be replaced.
FIG. 6 - FUEL TANK & FILTER
OPERATOR’S SEAT
The Operator’s Seat (12-C) may be moved either for¬
ward or toward the rear of unit to enable individuals
of varying heights to comfortably steer and control
the rider.
To adjust the seat, loosen the 2 three prong knobs
(A) located on the underside of the slotted mounting
bracket. Move the seat in the desired direction, and
then retighte'n both knobs.
Also, for taller operators, the offset steering wheel
may be rotated 180 degrees. If assistance is needed,
contact your SNAPPER Dealer.