Snapper 14 Series User Manual

Section III- MAINTENANCE
C. Transmission shift lever and detent.
D. Clutch disc.
E. Yoke.
F. Mower deck linkage and pivot areas.
3.6 STORAGE (OUT OF SEASON)
If desired, the Rear Engine Rider can be stored on the
rear bumper. Perform the following procedures to in¬
sure the Rear Engine Rider will operate properly when
taken out of storage.
A. Thoroughly clean the Rear Engine Rider removing
all grass clippings and debris.
B. Perform maintenance and lubrication as described
in 3.3 AFTER EVERY 25 OPERATING HOURS.
C. Drain fuel from fuel tank.
D. Start engine and allow it to run until engine runs
out of fuel. This allows the carburetor and fuel
system to remain clean during storage.
E. Remove battery. See 4.6, D. BATTERY STOR¬
AGE.
F. Close vent on fuel filler cap.
G. Carefully stand Rear Engine Rider on rear bumper
in desired location for storage.
12

Snapper 14 Series Specifications

General

Brand	Snapper
Model	14 Series
Category	Lawn Mower
Language	English