Snapper 14 Series

Section IV- ADJUSTMENTS & REPAIR
4. With cell caps removed, connect battery charger
to battery terminals. Red to positive (+) terminal
and black to negative (-) terminal.
5. Slow charge battery at 1 amp for 10 hours.
6. If battery will not accept charge or is partially
charged after 10 hours of charging at 1 amp,
replace with new ba|^|y, |art number 6-0753.
E. BATTERY STORAGE
If Rear Engine Rider is to be stored out of season
on its rear bumper, it is essential the battery be
removed and stored to prevent leakage of elec¬
trolyte (acid).
1. Remove battery.
2. Perform battery service.
3. Bring battery to full charge, if required.
4. Store battery in an area away from the Rear
Engine Rider on a wood surface. DO NOT
STORE BATTERY ON A CONCRETE SUR¬
FACE.
Service Notes