Snapper 14 Series User Manual

Section II- OPERATING INSTRUCTIONS
2. Push clutch/brake pedal all the way down and
apply the park brake by lifting the park brake
lever to the "ON" position. While holding park
brake lever "ON" release clutch/brake pedal to
set park brake. Refer to Figure 2.7.
3. Move the transmission shift lever to the neutral
(N) position. See Figure 2.8.
4. Open vent on fuel filler cap. See Figure 2.9.
NOTE
Failure to open vent on the fuel filler cap or turn will
cause engine to stall.
5. Move engine speed control to the choke position
to start a cold engine. See Figure 2.10.
FIGURE 2.10
6. Turn key to the "START" position until engine
starts. See Figure 2.11.
NOTE
If after 5 seconds of cranking the engine does not
start, release the key and attempt starting again
after 30 seconds.
7. After engine starts, allow a brief warmup until
engine runs smooth.
8. Should the battery be too weak to start the
engine, use the following instructions to
manually start the 9hp, lOhp, 12hp,13hp, and
14hp engines. Units with 8hp engines will
require charging of the battery. See 4.6, D.
CHARGING BATTERY.

Snapper 14 Series Specifications

General

Brand	Snapper
Model	14 Series
Category	Lawn Mower
Language	English