Snapper 5241 - Page 7

UP FOR SMOOTH
PAVED SURFACES
*
SCRAPER BLADE
Your Snow Thrower is equipped with an adjustable
scraper on the inside leading edge of the collector
housing. Its purpose is to prevent wear and damage
to the housing. When the scraper itself wears down
close to the lower edge of the housing, loosen the
five nuts on the backside of the housing and slide
the scraper downward. Retighten the five nuts after
repositioning. Replace the scraper if badly nicked or
when it no longer can be adjusted below the edge of
the housing.
& SHIFT SCRAPER BLADE
FIGURE 9 - SCRAPER BLADE ADJUSTMENT
SERVICE ASSISTANCE
Contact your Snapper Dealer for replacement parts
or for assistance when service is needed to keep
your Snow Thrower in top condition. To obtain the
correct parts or advice for your particular model,
always report the model and serial numbers as
found on the nameplate attached to the frame. For
engine parts and service, contact the engine
manufacturer’s dealer in your area. Complete
PARTS and SERVICE (Overhaul and Repair) Manuals
are available for your Snow Thrower at nominal cost.
Order these from your Snapper Dealer.
Service Notes