Snapper LT145H38DBV User Manual

TROUBLESHOOTING
| PROBLEM PROBABLE CAUSE
CORRECTIVE ACTION |
BLADE(S) NOT
1 .Blade engagement lever in the 'OFF* position. 1. Move lever to the 'ON* position.
CUTTING
2. Blade belt requires adjustment.
2. Adjust mower belt.
3. Blade belt requires replacement.
3. Replace mower belt.
CUTTING GRASS
1. Uneven tire pressure. 1. Bring to proper pressure.
IMPROPERLY
2. Cutting height too low or high. 2. Adjust cutting height.
3. Engine speed too slow. 3. Move engine speed control to 'FAST'.
4. Forward speed too fast. 4. Move speed control to a slower speed.
5. Deck side to side level requires adjustment.
5. Adjust side to side level.
6. Deck front to rear level requires adjustment. 6. Adjust front to rear level.
7. Blade belt requires adjustment. 7. Adjust blade belt tension.
8. Blade belt requires replacement.
8. Replace blade belt
POOR GRASS
1. Engine speed too slow. 1. Move engine speed control to "FAST".
DISCHARGE
2. Forward speed too fast. 2 Move speed control to a slower speed.
3. Grass is wet. 3. Mow when grass is dry.
4 Excessively worn or damaged biade(s).
4. Service mower blade(s).
5. Build up of grass clippings and debris under deck.
5. Clean deck.
6. Improper blade(s) installed on deck.
6. Install proper SNAPPER blades.
7. Blade(s) installed improperly on deck.
7. Install blades properly.
BATTERY WILL NOT
1. Poor cable connections.
1. Cean cables and battery terminals.
CHARGE
2. Bad battery cell(s).
2. Replace with new battery.
3. Faulty alternator.
3. Contact engine manufacturer's dealer.
OIL LEAKING
1 Loose or missing oil filler cap. (Hydro Models Only)
1. Check oil level and replace oil cap.
PROM TRANSMISSION
2. Leaking axle seals. 2. Contact authorized SNAPPER dealer.
3. Leaking at casing seal.
3. Contact authorized SNAPPER dealer.
13

Snapper LT145H38DBV Specifications

General

Brand	Snapper
Model	LT145H38DBV
Category	Lawn Mower
Language	English