Snapper LT145H38DBV User Manual

OPERATING INSTRUCTIONS
PRE-START CHECKLIST
Make the following checks and perform service as re¬
quired before each start-up.
Check tires and add air as needed to bring pressure to
12psi in front tires and 10 psi in rear tires. If guards are
missing or damaged, Replace BEFORE using mower.
Check guards, deflectors and covers to make sure all are
in place and securely tightened.
Check engine oil. Add oil as needed to bring up to, but not
over, the full mark. Referto the engine owner's manual for
oil specifications.
Check operator's seat adjustment. Adjust as necessary.
Check blade engagement lever to insure it operates
properly. The blade engagement lever must be moved
manually from "ON’' to "OFP to stop blade.
Clean exterior surfaces of cutting deck, engine and tractor
from any accumulation of grass clippings and debris.
Keep engine air intake screens and cooling fins clean at all
times.
With engine "OFF" move the tractor outside and add fuel
to the fuel tank. Securely tighten fuel cap after refueling.
See Figure 4. Refer to engine owner's manual for fuel
specifications.
ADJUSTING OPERATOR S SEAT
FRONT TO REAR ADJUSTMENT
With engine "OFF", raise operator's seat and loosen the
two adjusting knobs on the seat support. See Figure 5.
Lower the seat.
Sit in the operator's seat and slide the seat forward or
backward until the clutch/brake pedal can be fully de¬
pressed comfortably.
Raise seat and tighten the adjusting knobs to secure seat
in position.
FIGURE 5
6

Snapper LT145H38DBV Specifications

General

Brand	Snapper
Model	LT145H38DBV
Category	Lawn Mower
Language	English