Tiller Head
Footnotes:
TP 400-5202-5-RT-N
Manual No. 7006033LARGE FRAME REAR TINE TILLERS
SERIES 2
33
Part No Descri
tionItem Qt
Note
1 * SPACER Was 32263 (Used on 5HP Only)
2 BRACKET, Mounting Was 47866 (Used on 8HP Only)
32* STUD Was 14381
4 7090187 2 WASHER, 5/16 Split Lock
5 7091511 2 NUT, 5/16-18 Hex Was 90196
6* SHIELD Was 38068
7 7090358 8 SCREW, 5/16-24 x 2 1/2" Hex Head Cap (Gr.8)
8 7014334 10 SPACER, .625 OD x .388 ID x .801 Long
9 7090815 8 SCREW, 3/8-16 x 1/2" Self Tapping (8HP) Was 90506
10 7036058 BRACKET, Mtg. Left (8HP)
7036033 BRACKET, Mtg. Left (5HP)
11 7036057 BRACKET, Mtg. Right (8HP)
7036034 BRACKET, Mtg. Right (5HP)
12 7092062 8 NUT, 5/16-24 Hex Lock Was 11201
13 7090799 6 BOLT, 5/16-18 x 5/8" Short Neck Carriage
14 7035060 COVER, TINE
15 7035063 PLATE, Right Side
16 * MOULDING, Trim Was 14422
17 7090122 6 WASHER, 3/8" Flat
18 7090134 3 SCREW, 3/8-16 x 3/4" Hex Head Cap (Gr.2)
19 7091302 3 NUT, 3/8-16 Hex Was 90130
20 7036036 1 GUARD, Splash
21 7091619 2 NUT, 3/8-16 Flange Lock (5HP only) Was 90613
22 7013633 GRIP, Depth Bar
23 7047808 STRUCTURE, Depth Bar
24 7091601 16 NUT, 5/16-18 Hex Flange Lock Was 90585
25 7021866 SPACER, .5 OD x .33 ID x .4 Long
26 7051375 ASSEMBLY, Tiller Chain Case (See "Main Chain Case"
Illustration & Parts List)
27 7090209 SCREW, 5/16-18 x 1" Hex Head Cap
28 7090289 2 NUT, 3/8-24 Hex Center Lock
29 7014586 2 BOLT, 3/8-24 x 2 1/4" Shear
30 ASSEMBLY, Tine 13" (8HP)(See Tine Assembly Group) Was 51513 and 60687
ASSEMBLY, Tine 11.5" (5HP)(See Tine Assembly Group) Was 51579 and 60749
31 7090188 3 WASHER, 5/16 Flat (3)
32 7091841 2 SCREW, 5/16-18 x 1" Self Tapping Was 90369
33 7014875 FINGER, Belt
34 7011714 PIN, Hair 2.25" (8HP)
* NOTE: This part may be available from DPNI 1-800-558-1848 (Todd Graff)
To Next Page
Loading...
