RegWPMaintenance
7. Install the new chevron belt on the right-hand sprocket
and make sure that the belt is properly seated in the
chevron of the sprocket.
8. Referto Figure42. Align the holes in the sprockets with
the spindle mounting hardware as shown. The blades
will be perpendicular to eachother.
9. Install the new chevron belt on the left-hand sprocket
and make sure that the belt is properly seated in the
chevron of the sprocket.
10. Carefully rotate the breaker bar CLOCKWISEand install
the deck drive belt on the stationary idler pulley (D,
Figure41). Carefully releasethe tension on the breaker
bar. When the idler arm is releasedit will position the
stationary idler pulley and the chevron belt idler pulley
(B & C, Figure40) in the correct position.
11. Tighten the hardwarethat secures the stationary idler
pulleyand the chevron belt idler pulley to the cutter
deck.
12. Reinstall the mower deck guards.
13. Run the mower under no-load condition for about 5
minutes to break-in the newbelt.
!
Figure42. BladeAlignment (36" Models)
33
To Next Page
Loading...
