EasyManua.ls Logo

Snapper S50XBS2648 - Troubleshooting Commoncutting Problems

Snapper S50XBS2648
48 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TroubleshootJflg
TroubleshootingCommonCutting
Problem
Streaking.
Scalping.
Problems
Cause
1. Blades are not sharp.
2. Bladesare worn down to far.
3. Enginespeed is too slow.
4. Ground speed istoo fast.
5. Deck is plugged with grass
6. Not overlapping cutting rows
enough.
7. Not overlapping enough when
turning.
1. Lawn isuneven or bumpy.
2. Mower deck cutting height is
settoo low.
3. Ground speed istoo fast.
4. Deck is not leveledcorrectly.
5. Tire pressure is low or uneven
Remedy
1.Sharpenyourblades.
2. Replaceyour blades.
3. Always mow at full throttle.
4. Slow down.
5. Cleanout the mower.
6. Overlapyour cutting rows.
7. When turning your effective cutting width
decreases-overlap more when turning.
1. Roll or level the lawn.
2. Raisethe cutting height.
3. Slow down.
4. Correctly level the deck.
5. Check and inflatethe tires.
SteppedCutting. 1. Deck is not leveledcorrectly.
2. Tires are not properly inflated.
3. Bladesare damaged.
4. Deck shell is damaged.
5. Mower spindle is bent or loose.
6. Bladesare installed incorrectly.
1. Levelthe deck correctly.
2. Check and inflate the tires.
3. Replacethe blades.
4. Repair or replacethe deck.
5. Repair or replacethe spindle.
6. Reinstall the blades correctly.
Uneven Cutting.
Stingers.
1. Deck is not leveledcorrectly.
2. Bladesare dull or worn.
3. Bladesare damaged.
4. Deck is clogged with grass
clippings.
5. Deck shell is damaged.
6. Mower spindle is bent or loose.
7. Bladesare installed incorrectly.
8. Tires are not properly inflated.
1. Blades are not sharp or nicked.
2. Bladesare worn down too far.
3. Enginespeed is too slow.
4. Ground speed istoo fast.
5. Deck is plugged with grass.
1. Levelthe deck correctly.
2. Sharpen or replace the blades.
3. Replacethe blades.
4. Cleanout the deck.
5. Repair or replacethe deck.
6. Repair or replacethe spindle.
7. Reinstall the blades correctly.
8. Check and inflate the tires.
1. Sharpen your blades.
2. Replaceyour blades.
3. Always mow at full throttle.
4. Slow down.
5. Cleanout the mower.
42 www.SnapperPro.corn

Related product manuals