Snapper SPX-100 - Specifications; Engine and Electrical Specifications; Fuel and Air;Valve Clearance Specs; Power Ratings and Parts

22
Specifications
Power Ratings
The gross power rating for individual gasoline engine models is labeled in accordance with SAE (Society of Automotive
Engineers) code J1940 Small Engine Power & Torque Rating Procedure, and is rated in accordance with SAE J1995.
Torque values are derived at 2600 RPM for those engines with “rpm” called out on the label and 3060 RPM for all others;
horsepower values are derived at 3600 RPM. The gross power curves can be viewed at www.BRIGGSandSTRATTON.
COM. Net power values are taken with exhaust and air cleaner installed whereas gross power values are collected without
these attachments. Actual gross engine power will be higher than net engine power and is affected by, among other things,
ambient operating conditions and engine-to-engine variability. Given the wide array of products on which engines are
placed, the gasoline engine may not develop the rated gross power when used in a given piece of power equipment. This
difference is due to a variety of factors including, but not limited to, the variety of engine components (air cleaner, exhaust,
charging, cooling, carburetor, fuel pump, etc.), application limitations, ambient operating conditions (temperature, humidity,
altitude), and engine-to-engine variability. Due to manufacturing and capacity limitations, Briggs & Stratton may substitute
an engine of higher rated power for this engine.
See an authorized dealer.
Parts and Accessories
Item Briggs & Stratton Briggs & Stratton Briggs & Stratton
Cylinder Single Twin Twin
Displacement 30.59 cu in. (501 cc) 40.03 cu in. (656 cc) 44.18 cu in. (724 cc)
Electrical System Alternator: 9 amp Regulated
Battery: 12V-195 CCA
Alternator: 9 amp Regulated
Battery: 12V-195 CCA
Alternator: 9 amp Regulated
Battery: 12V-230 CCA
Engine Oil Capacity 48 oz (1,4 L) 62 - 64 oz (1,8 - 1,9 L) 62 - 64 oz (1,8 - 1,9 L)
Spark Plug Gap 0.030 in. (0,76 mm) 0.030 in. (0,76 mm) 0.03 in. (0,76 mm)
Spark Plug Torque 180 in-lbs (20 Nm) 180 in-lbs (20 Nm) 180 in-lbs (20 Nm(
Fuel Tank Capacity 3.5 gal (13,2 L) 3.5 gal (13,2 L) 3.5 gal (13,2 L)
Armature Air Gap 0.010 - 0.014 in. (0,25 - 0,36
mm)
0.008 - 0.012 in. (0,20 - 0,30
mm)
0.008 - 0.012 in. (0,20 - 0,30
mm)
Intake Value
Clearance
0.003 - 0.005 in. (0,08 - 0,13
mm)
0.004 - 0.006 in. (0,10 - 0,15
mm)
0.004 - 0.006 in. (0,10 - 0,15
mm)
Exhaust Valve
Clearance
0.005 - 0.007 in. (0,13 - 0,18
mm)
0.004 - 0.006 in. (0,10 - 0,15
mm)
0.004 - 0.006 in. (0,10 - 0,15
mm)
* This spark ignition system complies with Canadian ICES-002.