Snapper ZF2200K User Manual

TROUBLESHOOTING
PROBLEM
Starter Will Not Crank
Engine
Engine Will Not Start
Engine Stalls After
Running
Engine Loses Power
Engine Backfires When
Turned To "STOP"
Excessive Vibration
1,
2.
3.
4.
1
2.
3.
4.
5.
6.
7.
1
2.
3.
4.
5.
6.
7.
1
2.
3.
4.
5.
6.
1
1
2.
3.
PROBABLE CAUSE
Battery dead•
Blown fuse.
Electrical connections loose or corroded•
1,
2.
3.
Defective ignition switch• 4.
• Blade engagement switch in the "ON" position• 1
Park brake not set. 2.
Fuel tank empty• 3.
Engine needs choking• 4.
Spark plug wire disconnected• 5.
Battery weak or dead. 6.
Faulty parking brake, blade or ignition switch• 7.
• Operator not in seat. 1
Choke control in the "CHOKE" position• 2.
Fuel tank empty• 3.
Engine air pre-cleaner and or air cleaner dirty• 4.
Spark plug defective or gap set improperly• 5.
Fuel filter stopped up. 6.
Water, debris or stale fuel in fuel system• 7.
• Excessive load on engine• 1
Engine air pre-cleaner or air cleaner dirty 2.
Engine oil level low. 3.
Engine cooling fins & air intake screen excessively dirty. 4.
Spark plug faulty• 5.
Water, debris or stale fuel in fuel system• 6.
•Throttle control set too "FAST"• 1
• Damaged or bent mower blades• 1
Loose blade components• 2.
Loose or missing air lift (if equipped)• 3.
CORRECTIVE ACTION
Service battery•
Replace fuse•
Clean and check connections for good contact•
Contact authorized SNAPPER dealer•
• Move blade engagement switch to "OFF".
Set park brake•
Fill fuel tank with fresh fuel.
Move choke control to "CHOKE" position•
Place spark plug wire onto spark plug.
Service battery•
Contact authorized SNAPPER dealer•
•Sit in operator's seat.
Move choke control to "OFF" position•
Fill with fuel to proper level•
Clean free of all debris•
Service spark plug.
Replace fuel filter•
Drain and clean fuel system•
• Lessen load.
Clean or replace filters•
Fill with engine oil to proper level•
Clean cooling fins, air intake screen of all debris•
Service spark plug.
Drain and clean fuel system•
•Set throttle control to "SLOW" and allow engine to
idle. Then, turn key to "OFF".
•Service mower blade(s).
Service and tighten loose parts.
Replace air lifts• Tighten to proper torque•
(Trouble Shooting Continued on Next Page)
20

Snapper ZF2200K Specifications

General

Brand	Snapper
Model	ZF2200K
Category	Lawn Mower
Language	English