EN - 16
Operation
Receive a call
When there is an incoming call, the telephone
rings and the MESSAGE WAITING LED flashes.
To answer a call:
Lift the corded handset from the telephone base
to answer or press .
Place a call
Lift the corded handset from the telephone base
or press . Listen for a dial tone and then
dial the desired number, or press a Speed Dial
key to dial a programmed number. The key
illuminates when in speakerphone mode.
End a call
Place the corded handset in the telephone base,
or press when in speakerphone mode.
Speed dial
To dial a speed dial number, press a speed dial key.
(CONCIERGE, FRONT DESK or ROOM SERVICE).
Volume
Listening volume can be adjusted from the
telephone base.whereas ringer volume cannot
be adjusted.
To adjust the listening volume:
During a call, press VOL+ / VOL- to adjust the
listening volume. The next call returns to the
default listening volume.
Mute
To mute the microphone:
1. During a call, press . The key
illuminates when the mute function is turned
on. You can hear the party on the other end
but they cannot hear you.
2. Press again to resume the conversation.
The light on the key turns off.
Speakerphone
During a call, press to switch a call
between the corded handset earpiece
mode and the speakerphone mode.
Press again to switch back to the corded
handset earpiece.
The key illuminates when in use.
3. In idle mode, press to activate the
speakerphone mode and key illuminates
when in speakerphone mode.
Message waiting indicator
When a new voice message is received, the
Message Waiting LED flahes.
Play messages
Press in idle mode to play messages.
To Next Page
Loading...
