Snoppa ATOM - Firmware update; Gimbal calibration

Notice: The ATOM will automatically connect to the last phone
paired by Bluetooth. So when connecting to other unpaired
phones, please make sure the Bluetooth is disconnected with the
last phone. You can press the menu button for ve times to clear
the former Bluetooth connection record and reconnect the new
Bluetooth device again.
8. Firmware update
To update the gimbal when there’re new functions, you will need
to update the gimbal’s rmware. In order to get the best
experience, please keep the rmware updated.
The rmware is checked, detected and updated in Snoppa app
setting menu.
Notice:
During the updating process, the mode indicator will ash blue
until the update nishes. Don’t lock the screen or switch the
Snoppa app to background in this case the updating is
interrupted.
Keep the phone and the ATOM placed together, if they are
separated the Bluetooth would be disconnected and the update
may fail.
If the update is interrupted, just update it again.
9. Gimbal calibration
[1] Connect the phone to the ATOM by Bluetooth.
[2] In the Snoppa App, nd the calibration buttons in the
setting-gimbal panel. First perform the“ Drift calibration”, and then
do the “Level calibration”.
The gyro sensor would be aected by environmental variations.
When the surrounding temperature changes or after transporting
it for a long distance, the gimbal may drift automatically or go out
of level when starting up, which is a normal phenomenon and can
be xed by performing calibration in the app.
7