To scan barcodes:
1. Open your application. Place the cursor where you want to enter data.
2. Press the trigger button to scan a barcode. Make sure the laser beam extends across the
entire width of the barcode.
For example, try scanning the following barcode:
IMPORTANT! Print out this page to scan the barcode. Do not scan it onscreen.
After data is read and sent to the phone, by default the CHS will beep once, the
LED will flash green, and the beam will turn off. The CHS 7NRx and 7P will also
vibrate to indicate that data is read. You can use the Scanner Settings utility (see
next page) or Command Barcodes
to modify the beep / LED / vibrate settings.
To configure an automatic Carriage Return or Tab after each scan of data, use the
Scanner Settings utility (see next page) or Command Barcodes
.
If no data is read in a few seconds, the beam will turn off, and you must try again.
To Disconnect:
To disconnect, turn off the CHS. Press and hold the power button for at least 3 seconds,
until the CHS beeps twice (high-low) and the blue LED turns off.
Automatic Reconnection:
After you power on the CHS, it will automatically try to connect to the last phone it paired
and connected to. Make sure your phone is in range with Bluetooth enabled and
SocketScan 10 is running.
If the CHS is connected to your phone and gets disconnected, it will try to reconnect for a
few minutes. Make sure the phone is on and in range. If the CHS cannot reconnect, it will
emit a long beep. Press the trigger button to restart the reconnection process.
See Appendix F for unpairing instructions.
80
To Next Page
Loading...
