34
To scan barcodes:
1. Open your application. Place the cursor where you want to enter data.
2. Press the trigger button to scan a barcode. Make sure the aiming beam extends across
the entire width of the barcode.
For example, try scanning the following barcode:
After decoding the barcode and sending it to the phone/tablet, by default the CHS
will beep once and vibrate, the LED will flash green, and the aiming beam will
turn off. You can use the Scanner Settings utility (see next page) or Command
Barcodes to modify the beep / LED / vibrate settings.
To configure an automatic Carriage Return or Tab after each scan of data, use the
Scanner Settings utility (see next page) or Command Barcodes
.
If no data is read in a few seconds, the beam will turn off, and you must try again.
To Disconnect:
To disconnect, turn off the CHS. Press and hold the power button for at least 3 seconds,
until the CHS beeps twice (high-low) and the blue LED turns off.
Automatic Reconnection: After you power on the CHS, it will automatically try to
connect to the last phone/tablet it paired and connected to. Make sure your
phone/tablet is in range with Bluetooth enabled and SocketScan 10 is running.
If the CHS is connected to your phone/tablet and gets disconnected, it will try to
reconnect for a few minutes. Make sure the phone/tablet is on and in range and
SocketScan 10 is running. If the CHS cannot reconnect, you will hear a long beep. Power
cycle the scanner to restart the reconnection process.
The CHS can only be paired with one device at a time. To use the CHS with a
different device, see Appendix F
for unpairing instructions.
To Next Page
Loading...
