47
Set Lengths for Code 93
Parameter # L1 = 0x1A, L2 = 0x1B
The length of a code refers to the number of characters (i.e., human readable characters),
including check digit(s) the code contains. Lengths for Code 93 may be set for any length,
one or two discrete lengths, or lengths within a specific range. To set lengths via serial
commands, see Setting Code Lengths Via Serial Commands on page 7.
One Discrete Length - Select this option to decode only those codes containing a selected
length. For example, select Code 93 One Discrete Length, then scan 1, 4, to limit the
decoding to only Code 93 symbols containing 14 characters. Numeric bar codes begin on
page 82. To change the selection or cancel an
incorrect entry, scan the Cancel bar code
on pag
e 84.
Code 93 - One Discrete Length
Two Discrete Lengths - Select this option to decode only those codes containing two
selected lengths. For example, select Code 93 Two Discrete Lengths, then scan 0, 2,
1, 4, to limit the decoding to only Code 93 symbols containing 2 or 14 characters.
Numeric bar codes begin on page 82. To change the selection or cancel an incorrect
entry, scan the Cancel bar code on page 84.
Code 93 - Two Discrete Lengths
To Next Page
Loading...
