WebCode
Enable/Disable WebCode
Parameter #0xF076
When enabled, the decoder decodes WebCode.
When disabled, the decoder does not recognize WebCode.
Enable: 0x01
Disable: 0x00
Set Lengths for WebCode
Length 1: Parameter # 0xF077
Length 2: Parameter # 0xF078
Lengths for WebCode may be set for any length, one or two discrete lengths, or lengths within a
specific range. The length of a code refers to the number of characters (i.e., human readable
characters), including check digit(s) the code contains. For instructions on how to set code
lengths via SSI command, please refer to “Setting Code Lengths via SSI” earlier in this chapter.
Enable/Disable GT WebCode
Parameter # 0xF079
When enabled, the decoder decodes GT Webcode.
When disabled, the decoder does not recognize GT Webcode.
Enable: 0x01
Disable: 0x00
76
To Next Page
Loading...
