Laser On Time
Parameter # 0x88
This parameter sets the maximum time decode processing continues during a scan
attempt. It is programmable in 0.1 second increments from 0.5 to 9.9 seconds.
To set a Laser On Time, scan the bar code below. Next scan two numeric bar codes
beginning on page 82 that correspond to the desired on time. Single digit number
s must
have a leading zero. For example, to set an on
time of 0.5 seconds, scan the bar code
below, then scan the “0” and “5” bar codes. To change the selection or cancel an
incorrect entry, scan the Cancel bar code on page 84.
Laser On Time
(Default: 3.0 sec.)
To Next Page
Loading...
