socomec DIRIS A-40 - Alarms; Alarms Upon Events

45EN
#(1(2 Ű 2.".,$"
ALARMS
10.1. Alarms upon events
Alarms can be generated when a threshold is exceeded for the electrical measurements, consumption, variations in
level or change in input status. Also, combinations can be made on the alarms created.
Up to 50 alarms detected are saved and timestamped; an alarm can have 3 distinct statuses: Alarm active, Alarm
BNLOKDSDC K@QLBNLOKDSDC@MC@BJMNVKDCFDC K@QLRB@MAD@BJMNVKDCFDCDHSGDQ@TSNL@SHB@KKXNQAXTRDQ
@BSHNM@RQDPTHQDC
4OSN@K@QLRENQ@MDKDBSQHB@KLD@RTQDLDMS@QDBNMjFTQDCODQHSDLNEDPTHOLDMS@MCENQBG@MFDRHMRS@STRNE@
digital input.
3GD@K@QLR@QDBNMjFTQDCNMSGDRBQDDMNQUH@SGD$@RX"NMjFRNESV@QD
Electrical parameters
q  K@QLTONMU@QH@SHNMHMSGDHMRS@MS@MDNTRNQ@UDQ@FDU@KTDNE@MDKDBSQHB@KU@KTD"TQQDMSUNKS@FDEQDPTDMBX
ONVDQONVDQE@BSNQ"NROGHG@QLNMHBCHRSNQSHNMQ@SD
q Selection of the hysteresis and high/low threshold
q Setting a time delay at the start and end of the alarm
q For the associated total harmonic distortion, voltage and current three-phase values, an alarm may be
FDMDQ@SDCHESGDBNMCHSHNMHRETKjKKDCNM@BNLAHM@SHNMNEOG@RDR
- .M@RHMFKDOG@RD/G@RD/G@RD/G@RD
- .M@KKSGDOG@RDRRHLTKS@MDNTRKX/G@RD@MC/G@RD@MC/G@RD
- .MNMDOG@RDNESGDSGQDDOG@RDR/G@RDNQ/G@RDNQ/G@RD
$W@LOKDNEBNMkFTQHMF@M@K@QLNMSGDBTQQDMSUH@$@RX"NMkF
9ROWDJHDQGFXUUHQWXQEDODQFHLQDWKUHHSKDVHQHWZRUN
q Alarms on voltage unbalances: Unba, Unb
q Alarm upon current unbalance: Inba, Inb
q Selection of the hysteresis and high/low threshold
q Setting a time delay at the start and end of the alarm