Do you have a question about the socomec DIRIS Digiware I-45 and is the answer not in the manual?
Display | LCD |
---|---|
Number of Inputs | 3 |
Rated current In | 5 A |
Measurement Category | CAT III |
Frequency Range | 45-65 Hz |
Power Measurement | Active, Reactive, Apparent |
Communication Interfaces | RS485, Ethernet |
Operating Temperature | -10 to +55 °C |
Communication Protocols | Modbus RTU, Modbus TCP |
Measurement Parameters | Voltage, Current, Power, Energy, Harmonics |
Power Supply | AC 100-240 V |
Dimensions | 96 x 96 mm |
Current Input | 5A or 1A |
Mounting | Panel mounting |
Current Measurement Range | 0-5 A |
Energy Measurement | Active, reactive, apparent energy |
Storage Temperature | -25°C to +70°C |
Protection Degree | IP20 |
Weight | 0.3 kg |
Critical safety information regarding potential hazards during operation and installation.
Covers key hazards including electrocution, burns, explosion, and device damage.
Outlines user responsibilities for correct installation, use, and compliance.
General instructions and best practices for installing the DIRIS Digiware system.
Crucial safety advice and recommendations to follow before and during installation.
Methods for mounting the main DIRIS Digiware modules.
How to connect the various components of the DIRIS Digiware system.
Connecting the display, power supply, and measurement modules within the system.
Details on the Digiware communication bus system.
Calculating power needs and understanding equipment power consumption.
Protocols and rules for system communication.
Essential rules for setting up RS485 and Digiware bus connections.
Methods for configuring the DIRIS Digiware system.
Using the Easy Config software for system setup and parameterization.
A step-by-step guide to configuring the system with Easy Config.
How to configure the system using the DIRIS Digiware D remote display.
How to configure and manage system alarms.
Configuring alarms triggered by specific system events or measurements.