Saving the measured data
The device starts saving data from the moment it takes the very
first measurement and saves them continuously until the memory is full.
When the memory is full, no more data can be saved. Saved measurement
data can be transferred on your PC for further review.
History parameters can be set in the Settings menu (Page 38).
More detailed measurement history information can be obtained
in «Soeks Device Manager» software if you connect your device to a PC.
Software Recovery
When absolutely necessary, you can hard reset the software of the
device and restore the factory settings but all your data will be lost.
To hard reset, hold both the left [↗] and right [↘], buttons and
press the middle button [•].
Chose the necessary option on the screen:
«Repair firmware» - not intended for the user! This option is only
intended for service center personnel.
«Repair all» - choose to hard reset the device. After the boot
indicator has filled up and disappeared, chose «Exit». The screen will go
blank and you can switch the device off.
«Exit» - choose to exit the reset mode without making changes.
To Next Page
Loading...
Need help?
General
