Safety Instructions
HS10 is a powerful headlamp. Never point the beam directly at a person, animal or moving vehicles.
Doing so could cause retinal damage. Please do not allow children to play with it. Strobe mode may
cause seizure in persons with photosensitive epilepsy.
Operating the headlamp for a long time in Turbo or High mode will warm it up. This is normal.
HS10 is intended to be used with a premium 16340 rechargeable battery.
When installing the battery, make sure the anode (+) side always faces towards the head/LEDs.
Unscrew the tailcap half a turn to avoid unwanted activation during transport. It also prevents the
battery from draining while the headlamp is in standby.
Avoid hitting or dropping the headlamp.
Specifications
Emitter: 1x Samsung LH351D LED with a lifespan of up to 50,000 hours
Battery options: 1x 16340 Li-Ion battery
Operating voltage: 3.0V - 4.2V (16340 battery)
Dimension: 67.2mm (length) × 22.5mm (head diameter)
Weight: 37 grams (without battery)
Headlamp body: Aerospace grade 6061 grade aluminum alloy, CNC manufactured to hard-anodized to
military grade specification type III, anti-abrasive finish to get solid built body, anti-crash geometry and
better heat exchange.
Fresnel Lenses - scratch and wear resistant
Automatic Stepdown: Turbo mode steps down to High mode automatically to preventoverheating.
Circuit Protection
Double-click to activate Turbo, it will automatically steps down to High mode to prevent overheating.
It automatically steps down to lower modes when the 16340 battery does not have enough power.
Battery Specifications
Rechargeable 16340 battery
Battery Installation: Unscrew the tailcap to insert one 16340
battery with the anode side (+) towards the head, then
screw the tailcap back on.
Operation Instructions
From OFF
1. Single click to turn ON, then single click to turn OFF.
2. Press and hold to turn on Moon. Then press and hold again to cycle through stepped modes.
3. Double clicks to activate Turbo. Double clicks again to activate Moon, single click to turn OFF, press and hold
to cycle through stepped modes.
4. Triple clicks to activate Strobe, double clicks again to cycle through Strobe-SOS-Beacon, then single click to
turn OFF.
5. Four fast clicks to activate lockout. 4 fast clicks again to deactivate lockout and return to the previous mode
setting. When the light is locked, the main LED blinks two times to show the status of being locked. While in
lockout, press and hold the button to activate Moon.
To Next Page
Loading...
