From ON
1. Single click to turn OFF except Turbo and Strobe
2. Press and hold to change brightness steplessly. Release the button stopping at current light mode.
3. Double clicks to activate Turbo. single click to return to previous mode, press and hold to cycle through
modes (Moon
–
Low
–
Medium
–
High).
4. Triple clicks to activate Strobe, double clicks again to cycle through Strobe-SOS-Beacon, single click to return
to previous mode.
5. Four fast clicks to toggle between stepped mode and ramping mode, The light flashes twice when it changes
mode.
Troubleshooting and Maintenance
Disassembling the sealed head can damage the headlamp and voids the warranty.
Sofirn Ltd. recommends using high-quality brand batteries. Damage by battery leakage voids the
warranty.
Remove the battery if the headlamp will not be used for an extended period of time.
To prevent self-discharge or accidental activation during storage or transportation, unscrew the tailcap
by half a turn or remove the battery.
Every 6 months threads should be wiped with a clean cloth followed by a thin layer of siliconegrease.
To maintain a proper level of waterproofness, replace worn-out o-rings with an approved spare.
Troubleshooting: Clean battery contacts regularly as dirty contacts may impair the performance of the
headlamp. If you experience problems (flicker, shine intermittently or failure turn on) the following root
causes and solutions should be tried:
Reason A: The battery needs a replacement.
Solution: Replace the battery with an approved type of a fully charged battery.
Reason B: Threads, PCB board contact or other contacts are dirty.
Solutions: Please clean the contact points with a cotton swab soaked in rubbing alcohol.
Reason C: The headlamp will not turn on upon first use.
Solution: Please do not forget to remove the insulation sticker from the battery on first use.
If the above methods do not work please refer to the warranty policy before contacting your authorized
distributor.
eu@sofirnlight.com wholesale@sofirn.cn
Please contact us if you have any questions.
If your product is defective please contact us for replacement within warranty period.
Manufacturer: Shenzhenshi Jinba Technology Co.,Ltd
Address: 1/F to 9/F, 1st Building, NO.110 Tenglong Industrial Center, Guanlan Street, Longhua New District,
Shenzhen 518000, China
To Previous Page
Loading...
