The above mentioned parameters are based on tests according to international flashlight testing standards
(ANSI/NEMA FL1) using one 5000mAh 21700 battery. Results may vary with different battery or under different
environmental conditions.
Specifications
Emitter: 4* LUMINUS SST-20 LEDs
Battery Option: 1x 21700 battery
Working Voltage: 2.7V-4.2V
Standby Drain: ≤130uA
Input: Type-A to type-C 5V 3A
Maximum Charging Current: 3A
Material: A6061-T6 aluminium alloy
Water Resistance: IP68 waterproof
Smooth reflector
Lens Type: Toughened glass lens
Size: 30.1* 29* 115mm
Weight: 79g(without a battery)
Spotlight beam angle: 25°, floodlight beam angle: 96°
Magnetic tail cap
Advanced Temperature Regulation (ATR) technology: ATR will adjust the brightness level automatically
when the temperature of the light rises to prevent overheating.
Low Battery Protection: Upon turning on the flashlight, it automatically detects the battery level. If the
battery level is low, the flashlight will automatically switch to the lower output mode.
Low Voltage Protection: While the flashlight is on, if the battery voltage drops below 2.7V while in eco
mode or moonlight mode, the output will be automatically disabled.
Reverse Polarity Protection: The flashlight comes with built-in protection against reverse polarity.
Voltage Warning: When the flashlight is turned on and the battery voltage is below 3V, the indicator will
flash red, and the flashlight will vibrate twice with a 1-minute interval between each vibration. This
indicates insufficient battery power, and it is recommended
Battery Option
Rechargeable li-ion battery
Battery Installation
To Next Page
Loading...
