If you want to play with all those Anduril functions, please go to standby first. Click tail
switch to turn on, then click side switch to turn main led off, but side switch indicator is
on. That’s called Standby.
Functions include:
While OFF (standby)
- 1C: On
- 1H: Ramp up (or down, if button was released less than a second ago)
- 2C: Turbo
- 3C: Battery check
- 3H: Strobe mode. In Strobe mode 2C the side switch to cycle through Candle Mode- Bike
Flasher- Party Strobe- Tactical Strobe- Lightning Storm
- 4C: Lockout mode
- 7C: Change the brightness of button LED (Low-High-Flash-Off)
- 13H: Factory reset
- 15C: Version check
While On
- 1C: Off
- 1H: Ramp up (or down, if button was released less than a second ago)
- 2C: Turbo
- 2H: Ramp down
- 3C: Smooth ramping/ Stepped ramping toggle
- 4C: Lockout mode
In Lockout mode with Simple UI, there are a few functions:
- 1H: Momentary moon
- 2H: Momentary low
- 3C: Unlock to standby
- 4C: Unlock to main led on
If you find it difficult to remember all those clicks,
you can reach me by scanning my WhatsApp QR code.
I am on the other side of earth with huge different
time zone, but I will reply asap.
Email address:
barry0892@hotmail.com
To Next Page
Loading...
