Sofirn SP60 - Lock and Unlock Functions; Smooth Ramping Operation; Safety and Troubleshooting; Important Safety Precautions

switch to cycle through Strobe-SOS-Beacon, one-click the switch to return to
previously used mode.
DIRECT ACCESS TO MOONLIGHT MODE: When the flashlight is off, hold the
switch for over one second to enter into Moonlight. Then one click to turn off or hold
the switch again to enter Low cycling through the general brightness settings.
LOCK/UNLOCK: When the flashlight is off, 4 fast clicks on the switch to lock the
flashlight. LED blinks twice to signal that the light is in lock mode. Fast two, three or
four clicks on the switch to unlock it returning to previously used mode. You can only
access to momentary-moonlight by holding the switch while being locked. LED will
flash twice to indicate the flashlight is in lock mode when you try other operations.
AUTOMATIC LOCKOUT: When the flashlight turns off after 3 minutes, it will
automatically enter lockout mode.
SMOOTH RAMPING
ON/OFF: Single click the switch to turn the light
RAMPING UP/DOWN: Hold and press the switch to change brightness steplessly.
Ramping changes its direction when the switch is being pressed again within 1.5
seconds. The LED flashes once when it reaches the lowest or highest end of the ramp.
Other operations are the same as stepped ramp.
SWITCH BETWEEN STEPPED RAMPING AND SMOOTH RAMPING
While the flashlight is on, fast four clicks to switch between stepped ramping and
smooth ramping. Emitter blinks twice to signal that the switch is completed.
Safety Instructions
 SP60 is a powerful flashlight. Never point it directly at a person, animal or
moving vehicles. Doing so could cause retinal damage. Please do not allow
children to play with it. Strobe mode may cause seizure in persons with
photosensitive epilepsy.
 Operating SP60 for a long time in high powered modes will quickly heat up the
flashlight. This is normal.
 Pay close attention to the proper installation of the battery. Always check that the
positive end of the battery faces the flashlight’s head.
 Please unscrew the tailcap half a turn to avoid unwanted activation during
transport. It also prevents the battery from draining while the flashlight is in
standby.
 Avoid hitting or dropping the flashlight.
Troubleshooting and Maintenance
 Disassembling the sealed head can damage the flashlight and voids the warranty.
 Sofirn, Ltd. recommends using high-quality brand batteries. Damage by battery
leakage voids the warranty.
 Remove the battery if the flashlight will not be used for an extended period of
time.