Need help?Do you have a question about the Sokkia 30R Series and is the answer not in the manual?
General| Brand | Sokkia |
|---|---|
| Model | 30R Series |
| Category | Measuring Instruments |
| Language | English |
Explains symbols used in the manual for warnings and notes.
Describes conventions for screens and illustrations in the manual.
Provides guidance on how to follow operational procedures in the manual.
Defines warning and caution symbols and their meanings for safe operation.
Instructions on using the tribrach clamp for securing the instrument.
Guidelines for protecting the instrument from moisture and dust.
General precautions for instrument handling, storage, and maintenance.
Details laser product classification for specific models.
Details laser product classification for specific models.
Identifies instrument parts, panel, keyboard, and guide light.
Illustrates the different operational modes and transitions of the instrument.
Covers power, display, target selection, laser/guide light, and softkey usage.
Details inputting letters/figures and selecting options from menus.
Explains mode transitions and wireless keyboard usage.
Provides step-by-step instructions for charging the instrument's battery.
Guides on safely inserting and removing the battery from the instrument.
Explains how to center the instrument over a survey point using the tripod.
Details the process of levelling the instrument using circular and plate levels.
Procedure to measure the included angle between two points.
How to set a specific horizontal angle as a reference.
Method for increasing precision by repeating angle measurements.
Explains how to measure angles and output data to external devices.
Verifies sufficient reflected light for accurate distance measurements.
Describes measuring distance and angle simultaneously.
How to retrieve previously stored measurement data.
Explains how to output distance measurement data.
Measures height to inaccessible points using the REM method.
Inputting station coordinates, instrument height, and target height.
Setting the backsight station's azimuth angle for coordinate calculations.
Calculating the 3D coordinates of a target point.
Determining instrument station coordinates using known points.
Determining instrument station elevation using known points.
Setting out points based on horizontal angle and distance.
Setting out points using pre-defined coordinates.
Setting out points at inaccessible locations using REM.
Establishing a baseline for setting out lines and points.
Locating specific points along a defined baseline using length and offset.
Measuring horizontal and vertical distances from a baseline.
Establishing a baseline for projecting points.
Projecting points onto a defined baseline and calculating their positions.
Finding a point's location using a single distance offset.
Finding a point's location using an angle offset.
Finding a point's location using two distance offsets.
Measuring distances and angles between multiple points without moving the instrument.
How to change the starting point for missing line measurements.
Calculating area by observing points sequentially around the perimeter.
Calculating area using pre-registered coordinate data.
Covers recording station, angle, distance, coordinate, and combined data.
Explains how to record notes and review stored JOB data.
How to choose the current and coordinate search JOBs.
Procedure for removing a JOB and its data from the instrument.
Registering, deleting, and reviewing known point coordinates.
Registering, deleting, and reviewing codes for data entry.
Configuring various instrument settings like EDM, reflector, and illumination.
Customizing softkey assignments for efficient operation.
Procedure for setting or changing the instrument's access password.
Resetting instrument settings and data to factory defaults.
Covers plate, circular, and tilt sensor leveling checks and adjustments.
Details collimation, reticle, optical plummet, and guide light checks.
Explains checks for additive distance constant and guide light.
Lists all standard accessories included with the instrument.
Lists optional accessories available for purchase separately.
Details various reflecting prisms and targets for measurements.
Describes power supply options and combinations for the instrument.
Information on FCC compliance and potential radio interference.
Compliance statement for Canadian interference regulations.
Declaration of conformity with European Community directives.
Procedure for manually calibrating the vertical circle indexing.
Explains atmospheric correction for accurate distance measurements.
To Next Page
