Need help?Do you have a question about the Sokkia SRX5 and is the answer not in the manual?
General| Type | Robotic Total Station |
|---|---|
| Angle Measurement | Absolute Encoder |
| Absolute Encoder | Yes |
| Distance Measurement | Yes |
| Wireless Technology | Bluetooth, Wi-Fi |
| Protection Class | IP65 |
| Laser Class | Class 3R |
| Laser Wavelength | 635 nm |
| Operating Temperature | -20°C to +50°C |
| Storage Temperature | -30°C to +60°C |
| Weight (without batteries) | 5.6 kg |
| Accuracy | 1 arc second |
| Reflectorless Range | 1, 000 m |
| Prism Range | 5, 000 m |
| Measurement Time (Fine mode) | 1.2 seconds |
| Measurement Time (Tracking mode) | 0.3 seconds |
| Display | Touchscreen |
| Battery Type | Li-ion |
Defines symbols used for warnings and cautions in the manual.
Introduces fundamental key operations for instrument use.
Step-by-step guide for centering the instrument on the tripod.
Procedure for levelling the instrument using screens and foot screws.
Troubleshooting steps for software problems using warm/cold boots.
Configuration options for automatic target sighting.
Procedure for using the auto-pointing function to sight targets.
Setting up the instrument for automatic target tracking.
Procedure for performing measurements using auto tracking.
How to measure the angle between two points, setting the first to 0°.
Procedure to check the strength of the returned signal for measurement.
Inputting instrument station coordinates, height, and target height.
Explains the guide light's function for setting out points.
Procedure for setting out points based on distance and direction.
Setting out points using pre-defined coordinates.
Settings for observation parameters like distance mode and tilt correction.
Configuration options for backlight, beep, EDM ALC, and color.
Settings related to Electronic Distance Measurement (EDM).
Customizing softkey assignments for efficient operation.
Instructions for performing a cold boot to restore factory settings.
To Next Page
