SolarEdge SE4000-16A

A plus sign (+) near the country indicates that another menu will be displayed after
selection.
2. Confirm your country selection in the confirmation screen: Toggle to YES and press
Enter.
Language
1. Select the Language option to set the language in which the LCD should display.
2. Confirm your language selection in the confirmation screen: Toggle to YES and
press Enter.
Communication
1.
Select the Communication option to define and configure:
The communication option used by the inverter to communicate with
the SolarEdge monitoring platform
The communication option used to communicate between multiple
SolarEdge devices or other external non-SolarEdge devices, such as
energy meters or loggers.
2. Select Server to set which communication method is used to communicate between
devices and the monitoring platform. Refer to Setting Up Communication on page
66 for a full description of these communication options.
NOTE
The Server menu shows only the communication options installed in the
inverter.
The following shows a hierarchical tree of the menu options in the Communication
menu.
For detailed information about all the configuration options, refer to the
Communication Options Application Note , available on the SolarEdge
website at http://www.solaredge.com/files/pdfs/solaredge-communication_
options_application_note_v2_250_and_above.pdf.
Communication
(1)
,
(2)
:
(1)
If ZigBee is connected, the Wi-Fi Conf menu is not displayed. If ZigBee is not connected, ZigBee Conf and Wi-Fi Conf
are both displayed with <N/A> and their menus are not accessible.
(2)
When using the SolarEdge GSM products, RS232 Conf menu is unavailable.
Chapter 6: User Interface 51
Three Phase System Installation Guide MAN-01-00057-4.1