Figure 1: StorEdge system components
NOTE
Additional SolarEdge inverters (without batteries) can be connected over
RS485. The inverters will participate in export limitation and Smart Energy
Management.
PV modules connected to power optimizers are not mandatory for charge/
discharge profile programming.
Additional References
This document describes basic system connection and configuration - PVsystem
(power optimizer strings), one inverter, one battery, and one meter.
For additional configuration options refer to the StorEdge Solution Applications -
Connection and Configuration Guide, available at:
Chapter 1: Overview 8
StorEdge Interface Installation Guide MAN-01-00621-1.1
To Next Page