6
E N
. Do not lay the 230 V mains cable and the 12 V DC cable in the same duct.
. Do not lay the cable so that it is loose or heavily kinked.
. Fasten the cables securely.
. Do not pull on the cables.
2.5 Operating the device safely
DANGER! Danger of electrocution
. Do not touch exposed cables with your bare hands.
WARNING!
Only use the device in closed, well-ventilated rooms.
CAUTION!
. Do not operate the device
- In salty, wet or damp environments
- In the vicinity of corrosive fumes
- In the vicinity of combustible materials
- In areas where there is a danger of explosions.
. Before starting the device, ensure that the power supply line and the plug are dry.
. Always disconnect the power supply when working on the device.
. Please observe that parts of the device may still conduct voltage even if the fuse has
blown.
. Do not disconnect any cables when the device is still in use.
NOTICE!
. Make sure the air inlets and outlets of the device are not covered.
. Ensure good ventilation.
To Next Page
Loading...
