Solatube HSE - Assign Remote as Secondary

For the most current Installaon Instrucons, please visit www.solatube.com/instrucons
Solatube Internaonal, Inc. | 2210 Oak Ridge Way | Vista, CA 92081-8341 | www.solatube.com | T: 888.SOLATUBE
© 2020 Solatube Internaonal, Inc. Part No. 951845 v1.1
6
Secondary
This funcon allows you to assign a second remote control as a SECONDARY. This allows you to use two remote controls to
operate skylights. Follow these steps if you want a secondary remote to do the same as the primary remote.
PLEASE NOTE: You must rst unpair the secondary remote from the skylight (Page 8) and then erase memory from the
secondary remote (Page 9) before performing the steps on this page.
Assign Remote As Secondary (Mirror / Clone Remote) and Copy Group
Using UP / DOWN buons
select the marked posions.
8 8
Hold simultaneously STOP
and DOWN buons unl
you enter conguraon
mode.
8 8
Procedure performed correctly. Blue backlight
ashes once on Primary and Secondary remote
controls.
8 8
1
Accept by pressing STOP
buon.
Display will begin to count
down. Within 30 seconds
complete the following steps
on the Primary remote (Add
DEVICE TO NETWORK)
8 8
3
0
l
l
Secondary Secondary Secondary
8 8
l
Primary
Hold simultaneously the
UP and STOP buons
unl the remote enters
conguraon mode.
8 8 1
Using UP / DOWN buons
select marked posion.
8 8
Accept by pressing STOP
buon.
Display will begin to count
down.
8 8
1
2
The Secondary remote has now learned the Primary remote control.
It is now necessary to copy the group from the Primary remote
control to the Secondary remote.
Please proceed to next page (Page 7 Copy Group) to complete
Cloning process.
1
8 8 1
Primary
Primary
Primary
Primary
8 8
1
Secondary