LCB FITNESS BIKE
28
GENERALMAINTENANCE
1. Wipe down all areas in the sweat path with a damp cloth after each workout.
2. If a squeak, thump, clicking or rough feeling develops the main cause is most likely one of two
reasons:
I. The hardware was not sufficiently tightened during assembly. All bolts that were installed
during assembly need to be tightened as much as possible. It may be necessary to use a
larger wrench than the one provided if you cannot tighten the bolts sufficiently. I cannot
stress this point enough; 90% of calls to the service department for noise issues can be
traced to loose hardware or the rear rails being dirty.
II. Dirt build-up on the rear rails and polyurethane wheels are also a source of noise.Noise from
build-up on the rails can cause a thumping sound that you would swear is coming from
inside the main body of the machine because noise travels, and is amplified in the tubing of
the frame. Clean the rails and wheels with a lint free cloth and rubbing alcohol. Stubborn
build-up can be removed with your thumbnail or a non-metallic scraper, like the back edge
of a plastic knife. After cleaning, apply a small amount of lubricant on the rails with your
fingers or a lint free cloth. You only need a thin coat of lubrication, wipe off any excess.
3. If squeaks or other noises persist, check that the unit is properly leveled before calling the service
department.
MAINTENANCE MENU IN CONSOLE SOFTWARE
The console has built in maintenance/diagnostic software. The software will allow you to change
the console settings from English to Metric and turn off the beeping of the speaker when a key is
pressed for example. To enter the Maintenance Menu (may be called Engineering Mode,
depending on version) press and hold down the Start, Stop and Enter keys keep holding the
keys down for about 5 seconds and until the display shows display “Engineering Mode”. Press the
Enter button to access the menu below. Press the Level
▲
/
▼
keys to navigate the menu.
A. KEY TEST - Will allow you to test all the keys to make sure they are functioning.
C. BRAKE TEST – Testing of the EMS brake.
D. DISPLAY MODE - Turn off to have the console power down automatically after 30 minutes of
inactivity.
E. PAUSE MODE - Turned on to allow 5 minutes of pause, turn off to have console.
B. UNIT MODE - Choose from English or Metric display readings.
F. KEY TONE - Turn on or off the beep sound when a key is pressed.
G. CHILD LOCK - Allows you to lock the keypad so no unauthorized use of the machine is
allowed. When the child lock is enabled, the console will not allow the keypad to operate
unless you press and hold the Start and Enter buttons for 3 seconds to unlock the console.
To Next Page
Loading...
