Troubleshooting & FAQs
78
SSL UF8 User Guide
UF8 LCD Messages
The LCDs of UF8 show certain information, depending on UF8's status.
Booting / UF8 Identify
This message is displayed when you power up UF8, accompanying the 'fader wave'.
You also see this state when you're clicking to identify UF8s from the HOME page of the SSL 360° software.
'Awaiting Connection to SSL 360° Software'
'UF8 Initialisation Complete' means that the UF8 hardware boot sequence has completed. 'Awaiting Connection to SSL 360°' means
that UF8 is waiting for the SSL 360° software to start running on the computer. You may see this message appear when logging
onto your computer, before the operating system has finished loading your user-profile and start-up items. You may also see this
message if you are yet to plug a USB cable from your UF8 into your computer.
'Layer Set To None'
If you see this message, you have not yet chosen a DAW profile for the UF8 Layer. Head to the UF8 page and select the DAW you
are using from the drop-down list.
'Waiting For DAW' (Pro Tools only)
If you have configured a Layer for Pro Tools but Pro Tools is closed or you have yet to configure UF8 as a MIDI controller in Pro
Tools, then you will see this message.
To Next Page
Loading...
Need help?
General
