TV setup
When you enter to “TV System” menu, you
can set TV saturation, TV contrast, TV
brightness, Auto switch off, Power on at,
digital audio output, TV Resolution, TV
Mode, TV Format
TV Format: You can switch the screen
aspect ratio mode. Now we provide below
options: 4:3 PS / 4:3 LB / 16:9 LB/16:9 FIT
TV Mode: you can switch the tv output
mode by NTSC、PAL and auto
Video Output: To set video output mode RCA (CVBS)/SCART (CVBS)/SCART (RGB)/YCBCR
(YUV)
TV resolution: You can switch video resolution circularly by the sequence 576P <-> 720P <->
1080i. This effect is equal to press V. Format Key under Full Screen and their last setting saving
will be efficient for each others.
Digital audio output: To set the both SPDIF and HDMI’s digital audio output mode. It has options
LPCM Out and BS Out,
- LPCM Out means system will decode no matter AC3 or PCM audio track data to be LPCM,
digital audio decoder or HDMI TV will get LPCM digital audio data.
BS Out means system won’t do AC3 decode just output AC3 RAW data to SPDIF and HDMI.
Power on at：
Auto switch off：You can set whether Automatic standby or not. If “On”, it will enter into standby
mode automatically if no operation for 3/4/5 hours
TV Brightness：Press right/left KEY to set TV brightness
TV Contrast：Press right/left KEY to set TV contrast
TV Saturation：Press right/left KEY to set TV saturation
Parental control
1. Change Password: To change password. You can input the new password in this item by using
number keys directly. After you filled in 4 digital numbers, the highlight will auto skip to confirm
Password and ask you to input the new password again.
Default password is “0000”.
2. Channel Lock: In order to enter to the locked channels, you should input the password. The locked
channels mark will show up a popup message on the screen and ask for the password.
3. Menu Lock: In order to enter to the menu, you should input Password.
Update & Backup
By pressing [Menu] and selecting “System”
setting, and press OK key enter to update &
backup menu when the highlight on the
upgrade & backup item
Upgrade by network：You can download new
software to this receiver by network
Image upgrade：you can download new
software to this receiver by external USB
memory device（the upgrade file format
support “*ssu”）
Image backup：Store the software backup to
USB memory device (support backup by user date/database and total flash)
To Next Page
Loading...