1. Basic Operations
1.1 Turn on STB
First, press the Power to turn on the unit.
When the STB is first used, there will play the first channel from the default Channel List. If the STB is
not first used, STB will play the same channel as last time before turning off.
1.2 Power
1. Press [Power] Key can enter the Standby state
2. In Standby state, press [Power] Key again can call back the unit and go on play the previous
channel
3. User can also disconnect the device’s main power to end the Standby state.
1.3 Channel Up/Channel Down
In full screen, press [CH Up/Dn] to change channel.
1.4 Volume Up/Volume Down-
In full screen, press [Vol +/-] to adjust volume.
1.5 Number
In full screen, use number key and press [OK] on the Remote Control Unit to change channel.
1.6 Mute
1. Press [MUTE] key to mute the sound and the screen will show up mute OSD.
2. Press [MUTE] key again to restore sound.
1.7 Pause
By pressing [Pause] key once, the picture and sound will be paused and then, by pressing [PAUSE]
key again, you can continue to watch.
1.8 Recall
Press [RECALL] key will directly switch to the previous channel that you played before current
channel.
1.9 Favorite
1. In full screen, press [FAV] key, it will display a window of “Favorite Group” on the left of the screen.
2. In the window of “Favorite”, you can move highlight by press [Ch Up/Dn] key and press [OK] key to
select favorite group.
3. You also can press [VOL +/-] keys to select different “Favorite Group”.
4. Press [Exit] key to exit the current window.
1.10 Audio
1 In full screen, press [AUDIO] key to open the “Audio” window on the screen.
2 You can modify the audio track by pressing [Ch Up/Dn] key and modify the audio mode by
pressing [VOL +/-] key among Left / Right / Stereo / Mono.
To Next Page
Loading...