TM5010/TM5030/TM5050
Folding Treadmill
25
.esu fo etunim lareves retfa pu semoc 7E / 6E :melborP
When E6 / E7 is displayed, remove safety key and insert it again to restart treadmill.
:noituloS
1. Reset incline value:
(2) W
(1) Hold SPEED and press START button for 3 seconds, until beep twice.
hen the position of incline is lower than middle level, press the MODE button and
INCLINE button. Hold both buttons and the incline will be raised. Release the two
buttons till the incline position is up to middle level.
(3) When the position of incline is higher than middle level, press the MODE button and
INCLINE button. Hold both buttons and the incline will be lowered. Release the two
buttons till the incline position is down to middle level.
Please try it for few times. If you can not get the incline moved, please contact local
distributor / place of purchase.
E6 / E7 goes away. If not, please contact your local distributor / place of purchase for
technical service.
2. Please check if red / white incline cables are well connected to MCB.
3. If the above steps can not reset incline, please contact your local distributor /
place of purchase for technical service.
.esu fo etunim lareves retfa pu semoc 9E :melborP
1. Upper control cable and lower control cable are not well connected. To solve the problem,
please check the wiring circuit.
2. Please contact your local distributor for technical service.
:noituloS
E2 comes up after several minute of use.
Problem:
console IC chip
2. Check the console IC chip pin if it is bent or well connected. To solve the problem, please
reconnect the console IC chip.
3. Please contact your local distributor for technical service.
Solution:
Troubleshooting (continued)
To Next Page
Loading...