Owner’s Manual
Personal Settings
Engineering Mode
Information viewed on screen
Press and hold MODE/ENTER and then SPEED
to enter engineering mode.
T
Then press MODE/ENTER to next screen for
personal setting or to show factory setting.
100 ENG
MODE
To set up the units of measurement in
metric (Si) or in English (En).
En or Si
To set up the pause time.
This allows you to set the amount of time the
treadmill will be paused prior to automatically
resetting. The options are 90,180, or 300
seconds prior to console reset.
PT
90 or 180 or 300
bz
On or OFF
init 0 or 1
To set up the treadmill starting speed after the
pause button is pressed.
0 indicates to start the treadmill at the lowest
speed.
1 indicates to start the treadmill at the pause speed
it was going prior to pressing the pause button.
WARNING: The audible alert is
turned on from the manufacturer
to warn the user that the treadmill
is starting or the speed is changing.
sole discretion of the user.
!
Press SPEED or to change.
Press MODE/ENTER to accept this setting and
to next screen.
Press SPEED or to change.
Press MODE/ENTER to accept this setting and
to next screen.
Press SPEED or to change.
Press MODE/ENTER to accept this setting and
to next screen.
26
To Next Page
Loading...