SolidRF SR14652002A - Step 6: Finalizing Outdoor Antenna Installation; Outdoor antenna mounting options; Seal and Fix the Connector

OptionB:Mountingonthesideof
thechimney(SecondChoice).
Step6:FinalizingOutdoorAntennaInstallation
OutdoorAntennaInstallation
Makesurethattheoutsideunit ismountedatleast3feetawayfromanywindows.
OptionA:OutsideRoofPoleMount
(BestChoice)Useanexistingpoleto
mounttheoutdoorunitintheoptimal
signallocation.Usethepicturefor
reference.
Onceyouhavetestedtheperformanceofthe signalboosterandmadeallnecessary
adjustments,it’stimetofinalizetheinstallation.
14
Inparticular,cablesforoutdoorantennalocations
mustbefixed.Otherwise,theinternalwiresofthe
cablewillbepulledoffafterthewindhasbeen
shakenforalongtime.Theamplifierwillnotreceive
thesignalandthesystemwillfailcompletely.
Asshowninthefigure,itisbesttohavethecable
aroundasingleturnshapeandthenfixit.
Long‐termrainormoistureerosion
candamagetheelectrical
characteristics of outdoor antenna
connectors.Makesureconnectors
arewellscrewedinandsealthe
connectorswithgluedtape.
SealandFixtheConnector


e
e
Securethecableto
preventcable
damagecausedby
windshaking