SolidRF SR14652002A - Trouble Shooting: How to confirm that oscillation has occurred; Confirming oscillation; Trouble Shooting: How to solve the problem of oscillation; Step 1: Ensure antenna separation

Step1:Keepenoughdistancebetween
indoorandoutdoorantennas
MinimumRequiredSeparationDistance
BetweenIndoorandOutdoorAntenna：
Straightlinedistanceover30feet(10meters)
or
20ft(6meters)horizontaldistance
13ft(4meters)verticaldistance(Asfaras
possible)
Howdoesoscillationhappened:
1. Indoorantennareceiveleaksignalfromtheoutdoorantenna;
2. Boosteramplifythesignalandthentransmitittotheoutdoorantenna;
3. Outdoorantennabroadcastthesignalintheair,someofthesignalbacktoindoor
antennabecomeleaksignal;
4. Ifthegainoftheboosterhigherthanthelossoftheleaksignal,theleaksignalwill
becomebiggerandbigger,finallyoscillationhappened.
19
TroubleShooting:Howtosolvetheproblemofoscillation


1. Panellightflashorsolidgreenafterpoweron;
2. Screwofftheindoorantennafromthebooster;
3. Restartthepowersupply;
4. Allindicatorlightsflashoncetimeafterpoweronshow
self‐testfinished;
5. Thepanellightdoesn’tflashorsolidon.
Suchasituationmeansyoursystemhasoscillationproblem.
TroubleShooting:Howtoconfirmthatoscillationhasoccurred
BoostedSignal
LeakSignal
d