SOLIS 90 - Handle Fuel with Care; Avoid Hot Exhaust; PTO Safety

24
2.38 Handle fuel with care:
!
It is highly flammable. Do not refuel the machine
while smoking or when near open flame or sparks.
!
Always stop engine before refueling machine. Fill
fuel tank outdoors.
!
Prevent fires by keeping machine clean of
accumulated trash, grease, and debris. Always clean
up spilled fuel.
!
Use only an approved fuel container for
transporting flammable liquids.
!
Never fill fuel container in pickup truck with plastic
bed liner. Always place fuel container on ground
before refueling. Touch fuel container with fuel
dispenser nozzle before removing can lid. Keep fuel
dispenser nozzle in contact with fuel container inlet
when filling.
!
Do not store fuel container where there is an open
flame, spark, or pilot light such as within a water heater
or other appliance.
2.39 Avoid Hot Exhaust
Servicing machine or attachments with engine running
can result in serious personal injury. Avoid exposure
and skin contact with hot exhaust gases and
components.
Exhaust parts and streams become very hot during
operation. Exhaust gases and components reach
temperatures hot enough to burn people, ignite, or
melt common materials.
2.40 PTO Safety
CAUTION: Remove PTO cap (A) only when the
PTO is to be used.
As soon as PTO-driven implement is removed, re-
install cap over PTO stub shaft.
The master shield (B) can be folded up to allow an
implement to be connected, but it must be folded down
again afterwards.
CAUTION: Never operate PTO unless the
master shield is in the position shown. Switch off the
PTO before raising the implement.
SAFETY NOTES
O P E R A T O R M A N U A L S O L I S 9 0 ( C R D I )
Fig 2-36
Fig 2-37
Fig 2-38