78
INDIVIDUALLY PROGRAMMING
A SINGLE (SIMPLE) ESPRESSO
With your SOLIS Caffespresso Pro, you can adjust the quantity for a single
(simple) espresso yourself and program the appliance for future use – setting
your personal coffee preferences. Place a cup under the group head and
proceed as follows:
1. To change the pre-programming, press the PROGRAM-button (O) once.
The machine will beep once and the PROGRAM-button will begin to flash.
This indicates the machine is in programming mode.
2. Press 1 Cup-button
to start espresso extraction from the portafilter. Once
the desired volume of espresso has been extracted into the cup, press the
1 Cup-button
again. The machine will beep twice to indicate the new
1 Cup volume has been set.
INDIVIDUALLY PROGRAMMING
A DOUBLE ESPRESSO
With your SOLIS Caffespresso Pro, you can adjust the quantity for a double
espresso yourself and program the appliance for future use – setting your
personal coffee preferences. Place a cup under the group head and proceed
as follows:
1. To change the pre-programming, press the PROGRAM-button (O) once. The
machine will beep once and the PROGRAM-button will begin to flash. This
indicates the machine is in programming mode.
2. Press 2 Cup-button
to start espresso extraction from the portafilter.
Once desired volume of espresso has been extracted in the cup, press the
2 Cup-button
again. The machine will beep twice to indicate the new
2 Cup volume has been set.
RESETTING DEFAULT VOLUMES
To reset the machine to the default 1 Cup or 2 Cup shot volumes, press and
hold the PROGRAM-button (O) until the machine beeps three times. Release
the PROGRAM-button – the machine will return to its original default set-
ting.
NOTE: Default setting means:
1 cup espresso shot volume is approximately 30 ml, 2 cups espresso shot volume is
approximately 60 ml.
Downloaded from www.vandenborre.be
To Next Page
Loading...
