SOLIS Solis-100K-5G - 7.5.6 Calibrate Energy; 7.5.7 Special Settings; 7.5.8 STD Mode Settings

.45..44.
7.5.13 Debug Parameter
Figure 7.24
Debug Parameter as shown as below:
This section is applicable to maintenance personnel only.
Press the UP/DOWN keys to scroll through items. Press the ENTER key to select.
Press the DOWN key to scroll and press the UP key to change the value.
Press the ENTER key to save the setting. Press the ESC key to cancel.
changes and return to the previous menu.
→
S16DAT1: +0000
S16DAT2: +0000
7. Normal operation 7. Normal operation
7.5.12 Restart HMI
ThefunctionisusedforrestarttheHMI.
This function is applicable by maintenance personnel only, wrong operation
will prevent the inverter from reaching maximum power.
7.5.8.1 Enable logic interface settings
Please follow below settings to enable the DRM. DRM default setting is “OFF” , if DRM set “ON”,
but the logic interface un-connected to the switch or the switch is open, the inverter HMI will
display “Limit by DRM” and the inverter output power will be limited to zero.
1. Select Initial Settings
2. Select DRM and set it “ON”
7.5.10 HMI Update
HMI Current Ver.: 02
YES=<ENT> NO=<ESC>
Selecting “Updater” displays the sub-menu shown below:
This section is applicable to maintenance personnel only.
Updater is for updating LCD firmware. Press the ENTER key to start the process.
Press the ESC key to return to the previous menu.
Figure 7.22
7.5.9 Restore Settings
There are 5 items in initial setting submenu.
Thescreenshowsasbelow:
Restore setting could set all item in 7.5.7 special setting to default.
Figure 7.21 Restore Settings
Are you sure?
YES=<ENT> NO=<ESC>
PresstheEnterkeytosavethesettingaftersettinggridoff.
PresstheESCkeytoreturnthepreviousmean.
7.5.11 External EPM Set
Figure 7.23 Set the Fail Safe ON/OFF
YES=<ENT> NO=<ESC>
Fail Safe Set:ON
This function is turned on when the EPM is external.
7.5.14 FAN Test
This section is applicable to maintenance personnel only.