11
MAINTENANCE
• For changing the oil and other maintenance operations on the motor (spark plugs, air filter, regulations), refer to the motor
manual provided.
• NB: To unscrew the oil drain plug of the motor, disassemble the rear cover (Fig. 8 Ref. B).
• Make a regular check of the oil level in the gearbox with the cap (Fig. 5 R ef. A) and topping up if necessary.
• Change the oil completely every 200 hours. Empty the gearbo x of oil by unscrewing the oil drain plug (Fig. 5 Ref. C)
• Let the oil drain completely. After screwing back the cap tightly, fill to the correct level with new oil recommended by the
manufacturer. Fig. 5 Ref. "A".
• If the grass is not cut in a satisfac tory manner despite the adjust ments, the blade must be sharpened or replaced. For
replacement as follows :
1. Remove the cable of motor spark plug.
2. Put on a pair of gloves.
3. Unscrew the grass divider (Fig.1 - Ref. “6”).
4. Loosen the 4 knife holde r.
5. Remove the blade and put the new or the sharpened one, only after having greased it.
6. Rescrew the knife holder, adjusting the m in such a way as the blade can slide well.
7. Fasten the grass divider and reapply the cable of the spark plug
Fasten the grass divider and reapply the cable of the spark plug
• For any mechanical repair, especially during the warranty period, we recommend to go to a specialised repair shop of the
dealer.
• For transporting convenie n ce, the handles can be disassembled by means of the two knobs (Fig. 8 Ref. A). The same is
recommende d for the cutting bar, which is easily disassembled by removing the special split pin on the bar support (Fig. 9).
Always use gloves and apply the protective strip to the blade.
• Regularly check that screws are tight. Pay special attention to the screws fastening the bar to its support
CAUTION
It is advised not to keep the motor running when the machine is not
being used for its specific purpose
.
SAFETY TESTS AND CERTIFICATION
Declaratio n of CE conformity in accordance with the directive 98/37 CE and the directive EMC 89/336/CE
Kleinmotoren GmbH , Stuttgarter Straße 41, D -71069 S indelfingen
We declare that the machine complies with the essential requirements for health and safety in accordance with Directive
98/37/CE.
POWER MOWER TYPE MODEL SOLO 531
For verification of the conformity with the above-mentione d Directives reference has been made to following specifications: UNI
EN ISO 12 100-1 and UNI EN ISO 12100-2; UNI EN 12733 for pushed motor mowers with rotating cutting blades or with
reciprocating motion used in agriculture, forestry and horticulture.
SOLO Kleinmotoren GmbH
SINDELFINGEN, 18/01/2006
Wolfgang Emmerich
Geschäftsführer
RESULT AND TESTS
TYPE POWER MOWER MODEL SOLO 531
Acoustic pressure to the operator’s ear: LpA 82 dB (A)
Testing conditions height 1.6 m handle midpoint.
Vibration to handles with weighting U NI EN 1033-1 value 4,9 m/s
2
.
This declarat ion of CE conformity is valid only if the product doesn’t undergo any changes or modifications without authorization.
To Next Page
Loading...
